Fire suppression systems 24V 2 wire bus control panel for FM200 Gas

Fire suppression systems 24V 2 wire bus control panel for FM200 Gas


The gas fire controller base on EN54 standard for FM200 gas release and alarm, by connecting smoke/heat detectors,manual alarm button,emergency start / stop button, aerosol fire extinguishing control device (or cylinder control device
Set), weighing device, gas release lights and other equipment, consisting of a complete set of automatic fire alarm and fire extinguishing control systems.


Specifications:

Woking Voltage:220-240VAC
Output voltage(system voltage): DC12V-DC28V
The maximum ripple voltage: 200 mV
Quiescent Current: 0.12A
Alarm current: 0.235A
Maximum output current: 24 / 3A
Relay output contact capacity: 24V / 2A, 220V / 1A
Each sound and light output power: 24V / 1A (Max)
Alarm zone:4zones
Quiescent current: 0mA min-2mA max
Recommended to use twisted pair wire: 1.5mm2
Recommended hit valve output parallel diode 1N4004 or 1N4007

ZONE1-ZONE4: connect smoke/heat detector,manual alarm button and other input alarm equipment,
ZONE1 and ZONE2:linkage "and" control output,
ZONE3 and ZONE4: only alarm function,cannot control output.
Recommended ZONE1 connect smoke detector, ZONE2 connect heat detectors. When ZONE1 and ZONE2 all alarms, the control panel will enter into the linkage output status the linkage lose
Out (the control panel in automatic mode) state